[Linux-stm32] [PATCH V2 17/22] ARM: dts: stm32: Enable Bluetooth on AV96

[Marek Vasut]

The WiFi/Bluetooth chip is attached to USART2 on AV96 as well, describe
it in DT to make it available. Remove BT LED and turn it into a shutdown
GPIO, because the GPIO line controls the BT_REG_ON signal. The LED is just
an indicator connected to the same line, but not the primary function.

Signed-off-by: Marek Vasut <marex at denx.de>
Cc: Alexandre Torgue <alexandre.torgue at st.com>
Cc: Manivannan Sadhasivam <manivannan.sadhasivam at linaro.org>
Cc: Maxime Coquelin <mcoquelin.stm32 at gmail.com>
Cc: Patrice Chotard <patrice.chotard at st.com>
Cc: Patrick Delaunay <patrick.delaunay at st.com>
Cc: linux-stm32 at st-md-mailman.stormreply.com
To: linux-arm-kernel at lists.infradead.org
---
V2: No change
---
 arch/arm/boot/dts/stm32mp157a-avenger96.dts | 23 ++++++++++++++-------
 1 file changed, 16 insertions(+), 7 deletions(-)

diff --git a/arch/arm/boot/dts/stm32mp157a-avenger96.dts b/arch/arm/boot/dts/stm32mp157a-avenger96.dts
index 12ee95d5adb1..29af5ed2ebb3 100644
--- a/arch/arm/boot/dts/stm32mp157a-avenger96.dts
+++ b/arch/arm/boot/dts/stm32mp157a-avenger96.dts
@@ -21,6 +21,7 @@ aliases {
 		mmc0 = &sdmmc1;
 		serial0 = &uart4;
 		serial1 = &uart7;
+		serial2 = &usart2;
 		spi0 = &qspi;
 	};
 
@@ -63,13 +64,6 @@ led4 {
 			default-state = "off";
 			panic-indicator;
 		};
-
-		led5 {
-			label = "blue:bt";
-			gpios = <&gpioz 6 GPIO_ACTIVE_HIGH>;
-			linux,default-trigger = "bluetooth-power";
-			default-state = "off";
-		};
 	};
 
 	sd_switch: regulator-sd_switch {
@@ -421,3 +415,18 @@ &uart7 {
 	pinctrl-0 = <&uart7_pins_a>;
 	status = "okay";
 };
+
+/* Bluetooth */
+&usart2 {
+	pinctrl-names = "default", "sleep";
+	pinctrl-0 = <&usart2_pins_a>;
+	pinctrl-1 = <&usart2_sleep_pins_a>;
+	st,hw-flow-ctrl;
+	status = "okay";
+
+	bluetooth {
+		compatible = "brcm,bcm43438-bt";
+		max-speed = <3000000>;
+		shutdown-gpios = <&gpioz 6 GPIO_ACTIVE_HIGH>;
+	};
+};
-- 
2.25.1