[Linux-stm32] [PATCH v4 0/4] Enable stmpe811 touch screen on stm32f429-disco board

[dillon min]

On Mon, Jun 15, 2020 at 5:08 PM Alexandre Torgue
<alexandre.torgue at st.com> wrote:
>
> Hi Dillon
>
> On 6/9/20 3:26 PM, dillon.minfei at gmail.com wrote:
> > From: dillon min <dillon.minfei at gmail.com>
> >
> > This patchset is intend to enable stmpe811 touch screen on stm32f429-disco
> > board with three dts and one i2c driver changes.
> >
> > has been validated by ts_print tool
> >
> > Changes log:
> > V4: indroduce 'IIC_LAST_BYTE_POS' to compatible with xipkernel boot
> >
> > V3: just add change log in [PATCH V3 3/4] below ---
> >
> > V2: remove id, blocks, irq-trigger from stmpe811 dts
> >
> > V1:
> > ARM: dts: stm32: add I2C3 support on STM32F429 SoC
> > ARM: dts: stm32: Add pin map for I2C3 controller on stm32f4
> > ARM: dts: stm32: enable stmpe811 on stm32429-disco board
> > i2c: stm32f4: Fix stmpe811 get xyz data timeout issue
> >
> > dillon min (4):
> >    ARM: dts: stm32: add I2C3 support on STM32F429 SoC
> >    ARM: dts: stm32: Add pin map for I2C3 controller on stm32f4
> >    ARM: dts: stm32: enable stmpe811 on stm32429-disco board
> >    i2c: stm32f4: Fix stmpe811 get xyz data timeout issue
> >
> >   arch/arm/boot/dts/stm32f4-pinctrl.dtsi | 12 +++++++++
> >   arch/arm/boot/dts/stm32f429-disco.dts  | 47 ++++++++++++++++++++++++++++++++++
> >   arch/arm/boot/dts/stm32f429.dtsi       | 12 +++++++++
> >   drivers/i2c/busses/i2c-stm32f4.c       | 12 ++++++---
> >   4 files changed, 80 insertions(+), 3 deletions(-)
> >
>
> DT patches applied on stm32-next. I changed node ordering in patch 3.
Okay, thanks.

Regards,
Dillon,
>
> Thanks
> Alex