[Linux-stm32] [PATCH v4 0/4] Enable stmpe811 touch screen on stm32f429-disco board

[Alexandre Torgue]

Hi Dillon

On 6/9/20 3:26 PM, dillon.minfei at gmail.com wrote:
> From: dillon min <dillon.minfei at gmail.com>
> 
> This patchset is intend to enable stmpe811 touch screen on stm32f429-disco
> board with three dts and one i2c driver changes.
> 
> has been validated by ts_print tool
> 
> Changes log:
> V4: indroduce 'IIC_LAST_BYTE_POS' to compatible with xipkernel boot
> 
> V3: just add change log in [PATCH V3 3/4] below ---
> 
> V2: remove id, blocks, irq-trigger from stmpe811 dts
> 
> V1:
> ARM: dts: stm32: add I2C3 support on STM32F429 SoC
> ARM: dts: stm32: Add pin map for I2C3 controller on stm32f4
> ARM: dts: stm32: enable stmpe811 on stm32429-disco board
> i2c: stm32f4: Fix stmpe811 get xyz data timeout issue
> 
> dillon min (4):
>    ARM: dts: stm32: add I2C3 support on STM32F429 SoC
>    ARM: dts: stm32: Add pin map for I2C3 controller on stm32f4
>    ARM: dts: stm32: enable stmpe811 on stm32429-disco board
>    i2c: stm32f4: Fix stmpe811 get xyz data timeout issue
> 
>   arch/arm/boot/dts/stm32f4-pinctrl.dtsi | 12 +++++++++
>   arch/arm/boot/dts/stm32f429-disco.dts  | 47 ++++++++++++++++++++++++++++++++++
>   arch/arm/boot/dts/stm32f429.dtsi       | 12 +++++++++
>   drivers/i2c/busses/i2c-stm32f4.c       | 12 ++++++---
>   4 files changed, 80 insertions(+), 3 deletions(-)
> 

DT patches applied on stm32-next. I changed node ordering in patch 3.

Thanks
Alex