[Linux-stm32] [PATCH 0/4] Add nvmem support on STM32

[Fabrice Gasnier]

On 2/13/19 11:34 AM, Srinivas Kandagatla wrote:
> 
> 
> On 13/02/2019 10:15, Fabrice Gasnier wrote:
>> On 1/30/19 5:38 PM, Fabrice Gasnier wrote:
>>> Non volatile memory area is available on STM32. It contains various
>>> factory programmed information such as unique device ID, analog
>>> calibration...
>>> This patchset adds NVMEM support to access these data.
>>
>> Hello,
>>
>> Gentle reminder for this new driver review
> Nvmem provider driver itself looks fine for me, but I am unable to take
> this as 5.1 material, as I normally take nvmem patches which are
> reviewed and ready before rc5.
> 

Hi Srini,
Thanks for the feedback.

> dt bindings patch needs an ack from DT maintainers.

I hope Rob cant take a look at it.

Best Regards,
Fabrice

> 
> Thanks,
> srini
>>
>> Best Regards,
>> Fabrice
>>
>>>
>>> Fabrice Gasnier (4):
>>>    dt-bindings: nvmem: Add STM32 factory-programmed romem
>>>    nvmem: Add driver for STM32 factory-programmed read only mem
>>>    nvmem: stm32: add support for STM32MP15 BSEC to control OTP data
>>>    ARM: dts: stm32: Add romem and temperature calibration on stm32mp157c
>>>
>>>   .../devicetree/bindings/nvmem/st,stm32-romem.txt   |  31 ++++
>>>   arch/arm/boot/dts/stm32mp157c.dtsi                 |  13 ++
>>>   drivers/nvmem/Kconfig                              |  10 +
>>>   drivers/nvmem/Makefile                             |   2 +
>>>   drivers/nvmem/stm32-romem.c                        | 202
>>> +++++++++++++++++++++
>>>   5 files changed, 258 insertions(+)
>>>   create mode 100644
>>> Documentation/devicetree/bindings/nvmem/st,stm32-romem.txt
>>>   create mode 100644 drivers/nvmem/stm32-romem.c
>>>