[Linux-stm32] [PATCH 18/35] drm/logicvc: set the panel orientation on the connector

[Dmitry Baryshkov]

The panel is used directly, without the panel bridge, so nothing sets
its orientation on the connector apart from the workaround in the
get_modes() of some panel drivers, which runs too late.

Assisted-by: LLM
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov at oss.qualcomm.com>
---
 drivers/gpu/drm/logicvc/logicvc_interface.c | 7 +++++++
 1 file changed, 7 insertions(+)

diff --git a/drivers/gpu/drm/logicvc/logicvc_interface.c b/drivers/gpu/drm/logicvc/logicvc_interface.c
index 81f760dc07f8..bcbb837c9675 100644
--- a/drivers/gpu/drm/logicvc/logicvc_interface.c
+++ b/drivers/gpu/drm/logicvc/logicvc_interface.c
@@ -194,6 +194,13 @@ int logicvc_interface_init(struct logicvc_drm *logicvc)
 		drm_connector_helper_add(&interface->drm_connector,
 					 &logicvc_connector_helper_funcs);
 
+		ret = drm_connector_set_orientation_from_panel(&interface->drm_connector,
+							       interface->drm_panel);
+		if (ret) {
+			drm_err(drm_dev, "Failed to set panel orientation\n");
+			goto error_encoder;
+		}
+
 		ret = drm_connector_attach_encoder(&interface->drm_connector,
 						   &interface->drm_encoder);
 		if (ret) {

-- 
2.47.3