[Linux-stm32] [PATCH 04/11] ARM: dts: stm32mp15: Add new pinmux groups for phycore and phyboard

[Alexandre TORGUE]

Hi Christophe

On 1/10/25 16:02, Christophe Parant wrote:
> Add add alternate pinmux for following interfaces used on
> phyBOARD-Sargas:
> - UART4
> - LTDC
> - DCMI
> - TIM5
> - SAI2
> 
> Fix "ethernet0_rgmii_pins_d" pinmux used on phyCORE-STM32MP15x:
> ETH_RGMII_GTX_CLK pin was missing.
> 
> Signed-off-by: Christophe Parant <c.parant at phytec.fr>
> ---
>   arch/arm/boot/dts/st/stm32mp15-pinctrl.dtsi | 164 ++++++++++++++++++++
>   1 file changed, 164 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/st/stm32mp15-pinctrl.dtsi b/arch/arm/boot/dts/st/stm32mp15-pinctrl.dtsi
> index 95fafc51a1c8..7b1063295da6 100644
> --- a/arch/arm/boot/dts/st/stm32mp15-pinctrl.dtsi
> +++ b/arch/arm/boot/dts/st/stm32mp15-pinctrl.dtsi
> @@ -216,6 +216,45 @@ pins {
>   		};
>   	};

...

> +	/omit-if-no-ref/
> +	uart4_idle_pins_e: uart4-idle-4 {
> +			pins1 {
> +					pinmux = <STM32_PINMUX('B', 9, ANALOG)>; /* UART4_TX */
> +			};
> +			pins2 {
> +					pinmux = <STM32_PINMUX('B', 2, AF8)>; /* UART4_RX */
> +					bias-disable;
> +			};
> +	};
> +
> +	/omit-if-no-ref/
> +	uart4_sleep_pins_e: uart4-sleep-4 {
> +			pins {
> +					pinmux = <STM32_PINMUX('B', 9, ANALOG)>, /* UART4_TX */
> +							 <STM32_PINMUX('B', 2, ANALOG)>; /* UART4_RX */

Check indent here.

> +			};
> +	};
> +
>   	/omit-if-no-ref/
>   	uart5_pins_a: uart5-0 {
>   		pins1 {