[Linux-stm32] [PATCH v2] net: stmmac: fix 'ethtool -P' return -EBUSY

[Hao Chen]

在 2021/7/19 下午4:52, Joakim Zhang 写道:
>> -----Original Message-----
>> From: Hao Chen <chenhaoa at uniontech.com>
>> Sent: 2021年7月19日 15:44
>> To: peppe.cavallaro at st.com
>> Cc: alexandre.torgue at foss.st.com; joabreu at synopsys.com;
>> davem at davemloft.net; kuba at kernel.org; mcoquelin.stm32 at gmail.com;
>> linux at armlinux.org.uk; netdev at vger.kernel.org;
>> linux-stm32 at st-md-mailman.stormreply.com; linux-kernel at vger.kernel.org;
>> Hao Chen <chenhaoa at uniontech.com>
>> Subject: [PATCH v2] net: stmmac: fix 'ethtool -P' return -EBUSY
>>
>> The permanent mac address should be available for query when the device is
>> not up.
>> NetworkManager, the system network daemon, uses 'ethtool -P' to obtain the
>> permanent address after the kernel start. When the network device is not up,
>> it will return the device busy error with 'ethtool -P'. At that time, it is unable to
>> access the Internet through the permanent address by NetworkManager.
>> I think that the '.begin' is not used to check if the device is up.
>>
>> Signed-off-by: Hao Chen <chenhaoa at uniontech.com>
>> ---
>>   drivers/net/ethernet/stmicro/stmmac/stmmac_ethtool.c | 6 ++++--
>>   1 file changed, 4 insertions(+), 2 deletions(-)
>>
>> diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_ethtool.c
>> b/drivers/net/ethernet/stmicro/stmmac/stmmac_ethtool.c
>> index d0ce608b81c3..7ccb0d738a1c 100644
>> --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_ethtool.c
>> +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_ethtool.c
>> @@ -412,8 +412,10 @@ static void stmmac_ethtool_setmsglevel(struct
>> net_device *dev, u32 level)
>>
>>   static int stmmac_check_if_running(struct net_device *dev)  {
>> -	if (!netif_running(dev))
>> -		return -EBUSY;
>> +	struct stmmac_priv *priv = netdev_priv(dev);
>> +
>> +	pm_runtime_get_sync(priv->device);
>> +
>>   	return 0;
>>   }
> After this code change, clocks always enabled even the NIC is not up, it's not good.
> Should implement .complete() to disable clocks after the info you got?
>
> Best Regards,
> Joakim Zhang
>> --
>> 2.20.1
>>
>>
> OK, I will implement .complete() in next version patch.Thanks.