[Linux-stm32] [PATCH V2 4/4] ARM: dts: stm32: Enable voltage translator auto-detection on DHCOM

[Marek Vasut]

The DHCOM SoM uSD slot has an optional voltage level translator, add
DT bindings which permit the MMCI driver to detect the translator
automatically.

Signed-off-by: Marek Vasut <marex at denx.de>
Cc: Alexandre Torgue <alexandre.torgue at st.com>
Cc: Linus Walleij <linus.walleij at linaro.org>
Cc: Ludovic Barre <ludovic.barre at st.com>
Cc: Ulf Hansson <ulf.hansson at linaro.org>
Cc: linux-stm32 at st-md-mailman.stormreply.com
---
V2: Rebase on next-20210122
---
 arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi | 7 ++++++-
 1 file changed, 6 insertions(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi b/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi
index ff70bd03a017..661d8d071296 100644
--- a/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi
+++ b/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi
@@ -408,14 +408,19 @@ &rtc {
 };
 
 &sdmmc1 {
-	pinctrl-names = "default", "opendrain", "sleep";
+	pinctrl-names = "default", "opendrain", "sleep", "init";
 	pinctrl-0 = <&sdmmc1_b4_pins_a &sdmmc1_dir_pins_a>;
 	pinctrl-1 = <&sdmmc1_b4_od_pins_a &sdmmc1_dir_pins_a>;
 	pinctrl-2 = <&sdmmc1_b4_sleep_pins_a &sdmmc1_dir_sleep_pins_a>;
+	pinctrl-3 = <&sdmmc1_b4_init_pins_a &sdmmc1_dir_init_pins_a>;
 	cd-gpios = <&gpiog 1 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>;
 	disable-wp;
 	st,sig-dir;
 	st,neg-edge;
+	st,use-ckin;
+	st,cmd-gpios = <&gpiod 2 0>;
+	st,ck-gpios = <&gpioc 12 0>;
+	st,ckin-gpios = <&gpioe 4 0>;
 	bus-width = <4>;
 	vmmc-supply = <&vdd_sd>;
 	status = "okay";
-- 
2.29.2