[Linux-stm32] [PATCH v2 0/6] Add Stinger96 and IoT Box board support

[Alexandre Torgue]

Hi Mani

On 5/3/20 5:42 PM, mani at kernel.org wrote:
> From: Manivannan Sadhasivam <mani at kernel.org>
> 
> Hello,
> 
> This series adds Stinger96 and IoT Box board support. These boards are
> based on STM32MP157A SoC, designed and manufactured by Shiratech solutions.
> 
> The Stinger96 is a base board (96Boards IoT Extended edition) while IoT Box
> adds one mezzanine on top of it and sold as a gateway device.
> 
> This series depends on below patchsets already submitted and gone through
> reviews:
> 
> [PATCH v3 0/3] Add Reset and Wakeup support for CCS811
> [PATCH v3 0/2] Add CTS/RTS gpio support to STM32 UART
> 
> More information about these boards can be found in below links:
> 
> https://www.shiratech-solutions.com/products/stinger96/
> https://www.shiratech-solutions.com/products/iot-box/
> 
> Thanks,
> Mani
> 

Series applied on stm32-next.

Regards
Alex

> Changes in v2:
> 
> * Used "stm32" prefix for all DT commits
> * Dropped custom sdmmc2 pinctrl node since existing node itself has pullup
>    enabled and works fine.
> 
> Manivannan Sadhasivam (6):
>    dt-bindings: Add vendor prefix for Shiratech Solutions
>    ARM: dts: stm32: Add missing pinctrl entries for STM32MP15
>    dt-bindings: arm: stm32: Document Stinger96 compatible
>    ARM: dts: stm32: Add Stinger96 board support
>    dt-bindings: arm: stm32: Document IoT Box compatible
>    ARM: dts: stm32: Add IoT Box board support
> 
>   .../devicetree/bindings/arm/stm32/stm32.yaml  |   2 +
>   .../devicetree/bindings/vendor-prefixes.yaml  |   2 +
>   arch/arm/boot/dts/Makefile                    |   2 +
>   arch/arm/boot/dts/stm32mp15-pinctrl.dtsi      |  64 ++++
>   arch/arm/boot/dts/stm32mp157a-iot-box.dts     |  68 ++++
>   arch/arm/boot/dts/stm32mp157a-stinger96.dts   |  12 +
>   arch/arm/boot/dts/stm32mp157a-stinger96.dtsi  | 342 ++++++++++++++++++
>   7 files changed, 492 insertions(+)
>   create mode 100644 arch/arm/boot/dts/stm32mp157a-iot-box.dts
>   create mode 100644 arch/arm/boot/dts/stm32mp157a-stinger96.dts
>   create mode 100644 arch/arm/boot/dts/stm32mp157a-stinger96.dtsi
>