[Linux-stm32] [PATCH] ARM: dts: stm32: move ltdc pinctrl on stm32mp157a dk1 board

[Philippe CORNU]

Hi Yannick,

On 8/2/19 4:08 PM, Yannick Fertré wrote:
> The ltdc pinctrl must be in the display controller node and
> not in the peripheral node (hdmi bridge).
> 
> Signed-off-by: Yannick Fertré <yannick.fertre at st.com>
> ---
>   arch/arm/boot/dts/stm32mp157a-dk1.dts | 6 +++---
>   1 file changed, 3 insertions(+), 3 deletions(-)
> 
> diff --git a/arch/arm/boot/dts/stm32mp157a-dk1.dts b/arch/arm/boot/dts/stm32mp157a-dk1.dts
> index f3f0e37..1285cfc 100644
> --- a/arch/arm/boot/dts/stm32mp157a-dk1.dts
> +++ b/arch/arm/boot/dts/stm32mp157a-dk1.dts
> @@ -99,9 +99,6 @@
>   		reset-gpios = <&gpioa 10 GPIO_ACTIVE_LOW>;
>   		interrupts = <1 IRQ_TYPE_EDGE_FALLING>;
>   		interrupt-parent = <&gpiog>;
> -		pinctrl-names = "default", "sleep";
> -		pinctrl-0 = <&ltdc_pins_a>;
> -		pinctrl-1 = <&ltdc_pins_sleep_a>;
>   		status = "okay";
>   
>   		ports {
> @@ -276,6 +273,9 @@
>   };
>   
>   &ltdc {
> +	pinctrl-names = "default", "sleep";
> +	pinctrl-0 = <&ltdc_pins_a>;
> +	pinctrl-1 = <&ltdc_pins_sleep_a>;

Reviewed-by: Philippe Cornu <philippe.cornu at st.com>

Thanks
Philippe :)

>   	status = "okay";
>   
>   	port {
>