[Linux-stm32] [PATCH 4/8] dt-bindings: regulator: remove regulator pull-down support for stpmic1

[Pascal PAILLET-LME]

Regulator high pull down are enabled by default so remove support in the
driver.

Signed-off-by: Pascal Paillet <p.paillet at st.com>
---
 Documentation/devicetree/bindings/regulator/st,stpmic1-regulator.txt | 2 --
 1 file changed, 2 deletions(-)

diff --git a/Documentation/devicetree/bindings/regulator/st,stpmic1-regulator.txt b/Documentation/devicetree/bindings/regulator/st,stpmic1-regulator.txt
index de27897..bf9385b 100644
--- a/Documentation/devicetree/bindings/regulator/st,stpmic1-regulator.txt
+++ b/Documentation/devicetree/bindings/regulator/st,stpmic1-regulator.txt
@@ -23,8 +23,6 @@ Switches are fixed voltage regulators with only enable/disable capability.
 Optional properties:
 - st,mask-reset: mask reset for this regulator: the regulator configuration
   is maintained during pmic reset.
-- regulator-pull-down: enable high pull down
-  if not specified light pull down is used
 - regulator-over-current-protection:
     if set, all regulators are switched off in case of over-current detection
     on this regulator,
-- 
1.9.1