[Linux-stm32] [PATCH] ARM: dts: stm32: move ltdc pinctrl on stm32mp157a dk1 board

[Yannick Fertré]

The ltdc pinctrl must be in the display controller node and
not in the peripheral node (hdmi bridge).

Signed-off-by: Yannick Fertré <yannick.fertre at st.com>
---
 arch/arm/boot/dts/stm32mp157a-dk1.dts | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/arch/arm/boot/dts/stm32mp157a-dk1.dts b/arch/arm/boot/dts/stm32mp157a-dk1.dts
index f3f0e37..1285cfc 100644
--- a/arch/arm/boot/dts/stm32mp157a-dk1.dts
+++ b/arch/arm/boot/dts/stm32mp157a-dk1.dts
@@ -99,9 +99,6 @@
 		reset-gpios = <&gpioa 10 GPIO_ACTIVE_LOW>;
 		interrupts = <1 IRQ_TYPE_EDGE_FALLING>;
 		interrupt-parent = <&gpiog>;
-		pinctrl-names = "default", "sleep";
-		pinctrl-0 = <&ltdc_pins_a>;
-		pinctrl-1 = <&ltdc_pins_sleep_a>;
 		status = "okay";
 
 		ports {
@@ -276,6 +273,9 @@
 };
 
 &ltdc {
+	pinctrl-names = "default", "sleep";
+	pinctrl-0 = <&ltdc_pins_a>;
+	pinctrl-1 = <&ltdc_pins_sleep_a>;
 	status = "okay";
 
 	port {
-- 
2.7.4