[Linux-stm32] [PATCH 2/3] mtd: rawnand: stm32_fmc2: add STM32 FMC2 NAND flash controller driver

[Christophe Kerello]

Hi Boris,

On 09/24/2018 07:23 PM, Boris Brezillon wrote:
> Hi Christophe,
> 
> On Mon, 17 Sep 2018 17:47:39 +0200
> <christophe.kerello at st.com> wrote:
> 
>> +struct stm32_fmc2 {
>> +	struct nand_chip chip;
>> +	struct device *dev;
>> +	void __iomem *io_base;
>> +	void __iomem *data_base[FMC2_MAX_CE];
>> +	void __iomem *cmd_base[FMC2_MAX_CE];
>> +	void __iomem *addr_base[FMC2_MAX_CE];
>> +	phys_addr_t io_phys_addr;
>> +	phys_addr_t data_phys_addr[FMC2_MAX_CE];
>> +	struct clk *clk;
>> +
>> +	struct dma_chan *dma_tx_ch;
>> +	struct dma_chan *dma_rx_ch;
>> +	struct dma_chan *dma_ecc_ch;
>> +	struct sg_table dma_data_sg;
>> +	struct sg_table dma_ecc_sg;
>> +	u8 *ecc_buf;
>> +	int dma_ecc_len;
>> +
>> +	struct completion complete;
>> +	struct completion dma_data_complete;
>> +	struct completion dma_ecc_complete;
>> +
>> +	struct stm32_fmc2_timings timings;
>> +	u8 cs_assigned;
>> +	int cs_sel;
>> +	int ncs;
>> +	int cs_used[FMC2_MAX_CE];
>> +};
> 
> Can we have a clear separation between the NAND controller and NAND
> chip structures. I know you only support a single chip per-controller
> right now, but I prefer to have things clearly separated from the
> beginning.

Yes, I can create 2 structures: one for the controller (stm32_fmc2) and 
one for the NAND chip (stm32_fmc2_nand_chip).

Regards,
Christophe Kerello.

> 
> Regards,
> 
> Boris
>